How To Install And Adjust The Automatic Vertical Bandsaw Sawmill with Log Carriage?

What are the steps and requirements of install and adjust the automatic vertical bandsaw sawmill with log carriage, YSDMILL will analyze it for you.

1. Place the automatic vertical bandsaw sawmill stand on the foundation of the band sawmill smoothly.

2. The saw wheel is the main component of the wood working vertical band sawmill machine. The upper and lower saw wheels must be adjusted on a vertical plane. The edge of the outer diameter of the saw wheel should be perpendicular to the center of the saw edge of the machine base. The lower saw wheel is adjusted by the set-up bolts on the suspended bearing bracket. Adjustment of the upper saw wheel: Loosen the locking bolt after the upper saw wheel bearing seat, rotate the adjusting screw, the upper wheel bearing seat and the fuselage move relatively, so that the position of the upper wheel pressing the wheel can be accurately adjusted in the horizontal plane. 

3. The upper wheel lifting device is used to correctly adjust the center distance of the two wheels, so as to be tensioned and loaded and unloaded according to the length of the saw blade. Push the hand wheel forward, turn the hand wheel, the upper saw wheel can rise or fall in parallel. If you need to adjust the inclination of the upper saw wheel, pull the hand wheel back so that the pin on the hand wheel shaft is separated from the left bevel tooth. At this time, when the hand wheel is turned, only the right bevel tooth rotates. The right guide post can be lifted and lowered independently to achieve the purpose of adjusting the inclination. This can not only tension the saw blade, but also prevent the strip from channeling.

4. In order to ensure that the tension of the saw blade remains balanced during sawing, the wood working vertical band sawmill machine is equipped with a lever-type tensioning device. The weight of the hanging hammer must be increased or decreased according to the width and thickness of the saw blade used, and the size of the tension force of the saw blade. Generally not less than the recommended value.

5. This wood working vertical band sawmill is equipped with a saw card device to prevent the saw blade from swinging violently when it runs at high speed. The saw card can be raised and lowered frequently according to the size of the wood being cut. The lining of the saw card should be made of hard miscellaneous wood, and the end in the direction of the grain should be used to support the band saw blade. The gap between the saw clip and the saw blade is generally about 0.15-0.25mm.

6. This wood working vertical band sawmill is equipped with a backing device. Adjusting the distance between the backing plate and the band saw blade can saw various kinds of plates and materials of different specifications.