Call Us Today!    E-mali: info@ysdmill.com    WhatsApp: +86-15227677707

A professional sawmill machinery manufacturer

Sawmill Line / Wood Band Saw / Rip Saw / Blade Sharpener
Home » News » How to Replace the Band Saw Blade of a Wood Working Vertical Band Sawmill

How to Replace the Band Saw Blade of a Wood Working Vertical Band Sawmill

Views: 0     Author: Site Editor     Publish Time: 01-10-2024      Origin: Site

facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
whatsapp sharing button
sharethis sharing button

band saw blade

When replacing the band saw blade of the wood working vertical band sawmill machine, first open the protective door, loosen the fixing screw of the slide plate, turn the lifting handwheel, make the upper saw wheel drop, the band saw blade is loose, and take out the old band saw blade. Put the sharpened saw blade on the upper and lower saw wheels, pay attention to the direction of the sharp angle of the saw teeth downward, do not turn up. Then turn the lifting handwheel to raise the upper saw wheel and tension the saw blade. Then turn the upper saw wheel by hand to see if the saw teeth are all exposed on the outer side of the saw wheel rim. If not, adjust the upper saw wheel until the saw teeth are exposed on the rim, and move smoothly on the edge of the upper and lower saw wheels. perpendicular to the work surface.

The tensioning device of the band saw blade is divided into two types: spring and pressure thallium (heavy hammer). For the spring device, the basic tension should be determined according to the width, thickness and speed of the saw blade. Usually, the finger is used to press the saw blade, and whether the tension force is appropriate is determined according to the left and right bending of the saw blade. In general, when the saw blade is pressed by hand, the bending degree of the saw blade should be between 3.2 and 6.4 mm.


The width of the saw blade should be adapted to the width of the wheel surface of the saw wheel, and should not exceed the width of the wheel surface.

The saw blade is clamped in the middle of the saw clip, and the bottom of the saw teeth should be in a straight line with the outer edge of the saw clip. The saw blade should not be clamped too tightly, and should be able to slide in the middle of the saw clip. There should be a gap on both sides, and the gap on each side is about 0.04~0.08 mm. The back of the saw blade is about 0.8 mm away from the pulley. If the saw blade has contacted the pulley when idling, it means that the saw blade is behind, or the pulley is forward, or the saw blade is properly tensioned. Adjust the upper saw wheel or pulley, or remove the saw blade and then check the rolling trim.

View Contact

Contacts: Tony
Phone: +86-15227677707
WhatsApp: +86-15227677707
E-mail: info@ysdmill.com
Adress: Renze Zone, Xing Tai City, 
Hebei Province, China.

Product

Quick Links

Copyright © 2023 Xingtai Ysdmill Machinery Manufacturing Co.,Ltd. All Right Reserved