Installation And Debugging of Woodworking Vertical Band Sawmill before Use

Woodworking vertical band sawmill is often used in sawmills.But many people do not know how to properly install and debug the woodworking vertical band sawmill? YSDMILL will explain it to you today.

1. Place the tripod of woodworking vertical band sawmill steadily on the base of the band saw.

2. Saw wheel is the main component of woodworking vertical band sawmill machine.The upper and lower saw wheels must be adjusted in the vertical plane.The outer diameter edge of the saw wheel should be perpendicular to the center of the frame saw.Adjust the lower saw wheel by hanging the fixing bolt on the bearing bracket.Adjustment of the upper saw wheel: loosen the locking bolt behind the bearing seat of the upper saw wheel, turn the adjusting screw, so that the bearing seat of the upper saw wheel can move relative to any body, and the position of the upper saw wheel pressing down the lower wheel can be adjusted precisely in the horizontal plane.

3. The upper wheel lifting device is used to correctly adjust the center distance of the two wheels, so as to perform tension and loading and unloading according to the length of the saw blade.Push the handwheel forward, turn the handwheel, and the upper saw wheel can rise or fall in parallel.If the inclination of the upper saw wheel needs to be adjusted, pull the wheel back so that the pin on the handwheel shaft is embedded and separated from the left helical tooth.At this time, when the hand wheel rotates, only the right bevel gear rotates, and the right guide column can be lifted and lowered respectively through the screw to achieve the purpose of adjusting the inclination Angle.This can not only tighten the saw blade, but also prevent the saw blade from moving.

4. Woodworking band saw machine is equipped with lever tensioning device to ensure the balance of tension of saw blade when sawing. The weight of the hanging weight must be increased or decreased according to the width and thickness of the saw blade used.The tension of the saw blade is generally not less than the recommended value.

5. The woodworking band saw machine is equipped with a saw clamp device to prevent the saw blade from swinging violently at high speed. The saw can move up and down frequently depending on the size of the wood being cut.The lining of the saw shall be made of hardwood and applied along one end of the grain direction to resist the blade.The clearance between the saw and the blade is generally about 0.15-0.25mm.

6. Woodworking vertical band sawmill is equipped with backplane device. By adjusting the distance between the back plate and the saw blade, a variety of plates of different specifications can be cut.