1、 The hydraulic oil on the horizontal sawmill should be fully filled, and a layer of engine oil should be applied to the sliding and rotating parts.
2、 Horizontal sawmill is equipped with a band saw blade. Adjust the tightening device to ensure that the saw band is tightened to the appropriate level. At the same time, adjust the travel switch contact to just touch the blocking iron and it is in the open state.
3、 Fill the cooling water tank of the horizontal band sawmill with sufficient coolant.
4、 After completing the above preparations, connect the power supply and ensure that the grounding is standard and reliable. Turn on the power switch and start the band saw machine for testing. Correct the wiring according to the rotation direction indicated on the label, and listen for its normal sound. During operation, make the saw bow automatically lower, so that the saw band drops 0.5 to 1mm lower than the workbench. When the limit switch head collides with a collision block, it will automatically rise. When the limit position height is reached, whether it will automatically stop, and conduct three consecutive experiments. During operation, adjust the tension device to be in a relaxed state, make the travel switch contact leave the collision block, power off and shut down, and conduct three consecutive experiments.
5、 Check the lifting and lowering oil cylinder devices, check whether the saw bow is lifted and lowered reliably and flexibly.
6、 Check the clamping and loosening oil cylinder devices, check whether the clamping is reliable and whether the loosening is flexible.
7、 Adjust the speed control knob to run at 1st gear (low speed) and then at 2nd gear (high speed), and repeat the experiment three times.
8、 After the power switch of the main motor is turned on, the water pump starts correspondingly and the cooling system operates normally. Debug the valve and check if the coolant is smooth.
9、 After completing the above preparation work, clamp and lock the material for trial sawing.
