Views: 0 Author: Site Editor Publish Time: 01-09-2024 Origin: Site
1. Place the woodworking band sawmill stand on the foundation of the band saw smoothly.
2. The saw wheel is the main component of the customized wood working vertical band sawmill machine. The upper and lower saw wheels must be adjusted on a vertical plane. The edge of the outer diameter of the saw wheel should be perpendicular to the center of the saw edge of the machine base. The lower saw wheel is adjusted by the set-up bolts on the suspended bearing bracket. Adjustment of the upper saw wheel: Loosen the locking bolt after the upper saw wheel bearing seat, rotate the adjusting screw, the upper wheel bearing seat and the machine body move relative to each other, so that the position of the upper wheel pressing the wheel is accurate in the horizontal plane. Adjustment.
3. The upper wheel lifting device is used to correctly adjust the center distance of the two wheels, so as to be tensioned and loaded and unloaded according to the length of the saw blade. Push the hand wheel forward, turn the hand wheel, the upper saw wheel can rise or fall in parallel. If you need to adjust the inclination of the upper saw wheel, pull the hand wheel back so that the pin on the hand wheel shaft is separated from the teeth of the left bevel teeth. At this time, when the hand wheel is turned, only the right bevel teeth rotate. The right guide post can be lifted and lowered independently to achieve the purpose of adjusting the inclination. This can not only tension the saw blade, but also prevent the strip from channeling.
4. In order to ensure that the tension of the saw blade remains balanced during sawing, the quality wood working vertical band sawmill is equipped with a lever-type tensioning device. The weight of the hanging hammer must be increased or decreased according to the width and thickness of the saw blade used, and the size of the saw blade tension force. Generally not less than the recommended value.
5. The woodworking band sawmill is equipped with a saw card device to prevent the saw blade from swinging violently when it runs at high speed. The saw card can be raised and lowered frequently according to the size of the wood being cut. The lining of the saw card should be made of hard miscellaneous wood, and the end in the direction of the grain should be used to support the saw blade. The gap between the saw clip and the saw blade is generally about 0.15-0.25mm.
6. The woodworking band sawmill is equipped with a backing device. Adjusting the distance between the backing plate and the saw blade can saw various kinds of plates and materials of different specifications.